ASSEMBLY INSTRUCTION

Step 1 Unfold and open Balloon (1).
Step 2 Assemble Light Bulb (2) to Light Fixture (3).
Step 3 Place Circular Disk into 6” open port of the Balloon. Hold the Blower (7) with one hand while holding the Balloon with the other hand. Partially
inflate Balloon (1) until firm as shown in Fig. 1. Remove the Circular Disk.
Step 4 Insert Light Fixture Assembly into Balloon and twist tightly. CHECK FOR AIR TIGHT CONNECTION. Finish inflating the Balloon using the
Blower (7) through One Way Air Valve.
Step 5 Install Stabilization Base (5) to cradle the Balloon as shown in Fig. 2. Tighten thumb screw. Attach all Velcro Straps and tighten.
Step 6 Assemble Mast Sections (6) to desired height. Tighten thumb screws. Mount the Mast on Pivoting Mounting Post (9) horizontally as shown in fig. 3.
Step 7 Attach assembled Balloon Base to the Mast as shown in fig. 3. Tighten thumb screw.
Step 8 Connect the Ballast (8) with the extension cord to Pigtail at the base of the Balloon.
Step 9 Raise the Light Assembly as shown in fig. 3. Tighten thumb screw.
Step 10 Plug Ballast into Power Source. Switch Ballast on and “There shall be light.”
Step 11 To disassemble follow the steps in reverse order. Return components to their appropriate containers