Detectable Warning Tiles

Recommended Installation Procedure

1. Read and follow manufacturer instructions on the adhesive container.
2. Sweep the desired location to remove loose dirt and debris.
3. Tape off the desired installation area so as the inside dimensions are
   equal to the desired size.
4. Remove tube top, pull cap, cut bag tips, apply nozzle and insert into
   caulking gun.
5. Dispense adhesive until a uniform mixture is achieved prior to applying
   adhesive to tile.
6. Apply a uniform bead of adhesive to the tile as shown in the photograph.
7. Place the first detectable warning tile at one corner of the tape and apply
   pressure.
8. Repeat step 6 and 7 for additional tiles to achieve the desired panel size.
9. Use putty knife and push all squeezed out adhesive under the tiles.
10. Wait at least 30 minutes before removing the tape.
11. Protect the installed tiles from pedestrian traffic for 24 hours.

The above installation instructions are not meant to override applicable
codes or local agency's requirements.

Recommended Adhesive

• Sikadur AnchorFix-1- manufactured by Sika Corporation
• Tube Size: Net Per Tube 10.1 FL. OZ. (300 ml)
• Tube Coverage: 4 square feet
• Required Adhesive: 2.5 FL. OZ per square feet
• Tile Size: 12"X 12"
• Package Qty: 10 Tiles
• Package Wt. : 30 Lbs

BACK